Swing clamps, compact design, with threaded body (D)

Swing clamp cylinders operate single-acting with reset spring or double-acting hydraulically. The hydraulic oil supply can be connected by G1/8 threaded port or by manifold connection with O-ring. For any risk of exceeding the permitted volume flow a throttle check valve must be interposed into the oil supply line. Counter-hold the clamping arm when tightening or loosening the fixing cap screw in order to prevent torque transfer to the piston rod and to avoid damage to the ball guide.

The clamping procedure is initiated with a superimposed swing and stroke movement. After that, a linear clamping stroke follows. Cylinders with swing angles 0°, 45°, 60°, 90° are available as standard. The clamping force is depending from the length of the clamping arm. Except for the standard clamping arm also special clamping arms can be assembled. The maximum operating pressure of 350 bar only applies to clamping arms with a maximum length of 26 mm.

Important notice:

When installing the cylinder into the fixture plate the ventilation channel must be protected from ingress of liquids and dirt. If the swing clamp cylinder is screwed into a blind bore, the ventilation must be guaranteed through a protected bore. Before initial operation the swing clamp cylinder must be fully ventilated.

• integrated wiper made of FKM

• oil supply through drilled channels

• swing clamp mechanism easy to maintain

• standard clamping arms with contact bolts are available as accessories

• can be equipped with customer specific clamping arms

Design:

Type D, threaded body

The dimensioned installation contour can be found on the data sheet.

 

 

Mounting option:

Accessories:

Clamping arms and contact bolts
are available as a set of accessories.

Single clamping arm L = 26 mm
incl. contact bolt:
Order no.: SPE-126-001

Slotted nut:
Order no.: 4040-086

 

Operating pressure:

pmin. 25 bar - pmax. 350 bar

 

Operating method:

single-acting or double-acting

 

Swing angle:

0°, 45°, 60° and 90°

 

Design:

D (threaded body)

 

Piston Ø:

14 mm

 

Clamping stroke:

single-acting 6 mm, double-acting 8 mm

 

Clamping arm holder:

taper with cap screw, ratio 1:10

Overload protection:

without

 

Position control:

without

 

Oil supply:

drilled channels

Data sheet (PDF):

 

For technical details and dimensional drawings download the current data sheet.

 

Selection guide:

Our selection guide for swing clamp cylinders facilitates product selection. It contains the description of all features and a product overview.

 

Product configurator:

With our product configurator, you can put together your desired products step by step. Then the following options are available:

 

• generate an order number
• request a quote
• download of 3D models