Swing clamps, cartridge design with drilled channels (E)

This hydraulic swing clamp cylinder operates as double-acting pull cylinder, whereas part of the stroke is used to rotate the piston. The model with 0° swing angle operates only vertical as pull cylinder. To guarantee a long lifetime the cylinders have an integrated metal wiper as standard. For oil supply, the cylinders are equipped with threaded port and manifold connection with O-ring for drilled channels. You can select between right or left turning models with various standardized swing angles.The integrated overload protection protects the swing mechanism from damage due blockage of the rotation or improper assembly of the clamping arm.

For any risk of exceeding the permitted volume flow a throttle check valve must be interposed into the oil supply line. Counter-hold the clamping arm when tightening or loosening the counter nut in order to prevent torque transfer to the piston rod and to avoid damage to the ball guide. Variations with 0°, 30°, 45°, 60° and 90° swing angles are available. The permitted operating pressure is depending from the clamping arm length. Except from standard clamping arms also special clamping arms can be assembled. The maximum operating pressure of 500 bar does not apply for each clamping arm length. For details about the permitted operating pressure see data sheet.

Pay attention to cleanliness in the bore.

• protecting metal wiper

• pipeless oil supply via drilled channels

• integrated overload protection

• standard and special clamping arms available

• customer specific clamping arms can be mounted

Design:

Type E, cartridge design

The dimensioned installation contour can be found on the data sheet.

 

Clamping arm holder:

Taper, ratio 1:10

Clamping arms:

• SPK/c single clamping arm
• SPK/d single clamping arm
• SPK/e single clamping arm
• SPK/f  double clamping arm

 

Here you will find an overview of all standard clamping arms.
Special clamping arms are available on request.

 

Operating pressure:

pmin. 15 bar - pmax. 500 bar

 

Operating method:

double-acting

 

Swing angle:

0°, 30°, 45°, 60° and 90°

 

Design:

E (cartridge design)

 

Piston Ø:

25, 40, 50 or 63 mm

 

Clamping stroke:

11, 14, 15 or 25 mm

 

Clamping arm holder:

taper, ratio 1:10

Overload protection:

with

 

Position control:

without

 

Oil supply:

drilled channels

Data sheet (PDF):

 

For technical details and dimensional drawings download the current data sheet.

 

Selection guide:

Our selection guide for swing clamp cylinders facilitates product selection. It contains the description of all functions and a product overview.

 

Product configurator:

With our product configurator, you can put together your desired products step by step. Then the following options are available:

• generate an order number
• request a quote
• download 3D models