Lever clamps without/with position control

Lever clamp
built-in design
manifold connection with O-ring
(Type B)

Positions controls (Accessories)

fig. left:
inductive position controle
with proximity switch,
plug and cable

fig. right:
pneumatic position controle

Description

Application example

Data sheet 250-1

Request quote / 3D models

Lever clamp cylinders (lever clamps) are primary meant for individual cases, where the clamping position needs to be free for handling when the workpiece is unclamped. Compared to swing clamps, lever clamps have a more compact design and higher clamping load. Lever clamps are especially meant for those cases, where bothering contours make the use of swing clamps unsuitable. Through a piston the high force density is induced into the clamp lever. Since the clamp lever has a movable position, the clamping point can be fully released. Besides the standard clamp lever also special clamp levers can be mounted. The resulting clamping load can be determined through the chart on the data sheet.

Special features:

partly retractable housing
various installation options
fixture can be easily loaded and unloaded
clamp lever can be optimized on workpiece
inductive or pneumatic position control available
standard cylinders and special designs available

Operating conditions:

The lever clamp cylinder is only double-acting, hydraulic. Therefore, clear clamping times and unclamping times are given. For hydraulic oil supply G1/8 resp. G1/4 threaded port or manifold connection with O-ring can be used optional. In horizontal position the clamp lever provides its optimal clamping load. Workpiece tolerances with a position deviation of appr. +/-8.5° can be compensated easily.